Nissan Juke fitting guide


Turbosmart’s Kompact Plumb Back is now available for the Nissan Juke.

article_juke01

Installation is quite straight forward. The first thing to do is to unsnap the plastic engine cover and set it to the side. A gentle tug is all that is needed to remove it (no bolts or fasteners holding it down).

article_juke02This exposes the factory plastic diverter valve on the top of the motor:

article_juke03

Using pliers compress and slide back the factory clamps. Next carefully pull the hoses off.

article_juke04

Now, using a 10mm socket with an extension and swivel, remove the two mounting bolts and remove the factory diverter valve.

article_juke05Installation is the opposite of removal. Take your Turbosmart billet bypass valve and install using the supplied gasket.

article_juke06

Total installation time is 15 minutes.

Kompact_PB_Nissan

Kompact Plumb Back Nissan Juke. Part Number: TS-0203-1227
For more information go to the Kompact Plumb Back Nissan Juke product page.


2 thoughts on “Nissan Juke fitting guide

  1. Pingback: Injen charge pipe and Synapse DV help. :)

  2. Good day

    I am driving a 2012 Nissan Juke DIG Turbo (1.6)
    Please advise will there be any difference with car after replacing this part? (Turbosmart billet bypass valve)

    Thank you.

Leave a Reply

Your email address will not be published. Required fields are marked *

Connect with Facebook